Cooper Menvier SD3 Specifikace stáhnout pdf (Strana 13)

Programming SD1+

Option 5: Changing Your Passcode Type

When delivered from the factory, (or if you have just

initialised the unit) the SD1+ uses four-digit passcodes. If

you want to use a longer passcode, use option 5 to set

up six-digit passcodes.

When you change from four-digit to six-digit

passcodes SD1+ adds “00” to the end of your

current passcode.

If you want to change back from six-digit to four-digit

passcodes, use option 5 again.

If you change from six-digit to four-digit passcodes,

SD1+ removes the last two digits from the end of

your current passcode.

1. If necessary initialise the SD1+ .

SD1+

2. Key in the current passcode.

READY

3. Press 5, the display shows:

C,TYPE-

4. Press [.

If the SD1+ is currently using four-digit passcodes

the display shows:

If the SD1+ is using six digit passcodes the display

shows:

4, CODE

6, CODE

5. Press B. until the display shows the code length

you want to use, for example:

6, CODE

6. Press [ to accept the new passcode length and

return to “READY”.

READY

SD1+

Programming

Entering Programming Mode

To gain access to the program menus you must key in a

passcode. The default passcode is 1234.

1. In stand-by mode (not communicating) the display

shows:

SD1+

2. Key in your user code, for example 1234. The

display shows:

The SD1+ is now in programming mode.

READY

Leaving Programming Mode

1. Make sure the SD1+ is at the top level of the

programming menu (the screen shows “READY”).

READY

2. Press ]. The screen shows SD1+ and you have left

programming mode.

SD1+

Initialising a Unit

When you power up a new SD1+ for the first time the

memory is blank and the display shows “PLEASE

RECORD”. Once you have stored messages and

telephone numbers in the unit the display shows “SD1+”

when you return to standby mode. If you want to return a

unit to its blank state you can initialise it as follows:

PLEASE

RECORD

1. Remove all power from the unit.

2. Hold down 9 and reapply power. Release 9.

The display shows:

ERASE?

3. Press [. The display shows:

LANG ?

4. Press ].

The display shows:

PLEASE

RECORD

5. Key in the default pass code 1234.

The display shows:

READY

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Komentáře k této Příručce

Žádné komentáře

Cooper Menvier SD3 Specifikace Strana 13

Komentáře k této Příručce